ENGLISH
16
•
prepare the work area by removing all possible obstacles;
•
begin working from the furthermost point to avoid walking on the area you have just
cleaned;
•
choose the straightest possible working routes;
•
divide large floors into parallel rectangular sections.
If necessary, finish off by passing a mop or rag rapidly over parts inaccessible to the
scrubber drier.
6.7.
Working
i INFORMATION
The seat (fig. D, ref. 3) has a safety sensor which allows the machine to move only
when the operator is seated.
i INFORMATION
The machine (CT 230 only) has a safety system to prevent it tipping over. This
reduces the speed on bends, irrespective of the pressure exerted on the machine
movement pedal. This reduction of speed on bends is therefore not a malfunction,
but a feature which increases the machine's stability in all conditions.
i INFORMATION
When the machine movement pedal is released, all functions shut down
automatically within 5 seconds (Auto Power-Off). While the machine is in stand-by,
the light corresponding to the set programme will flash. To reactivate the
functions, just move the machine without deselecting the set programme (Auto
Power-On).
After setting up the machine, proceed as follows:
•
start the machine by turning the key (main switch) clockwise (fig. B, ref. 3).
•
Select the most suitable programme from the three available. Pressing one of the work
programme buttons activates all the functions of the chosen programme (brush motors
and suction motor on).
•
P1 (fig. B, ref. 1) light wash programme for smooth not excessively dirty floors.
•
P2 (fig. B, ref. 15) medium wash programme for smooth floors with evident dirt.
•
P3 (fig. B, ref. 2) heavy wash programme for rough floors (concrete etc.) with
stubborn dirt.
•
Press the detergent flow regulation buttons (fig. B, ref. 5): to set the quantity of
detergent delivered (displayed by LEDs).
•
use the direction selector (fig. B, ref. 12) to set the direction of movement;
•
press the machine movement pedal (fig. D, ref. 2).
•
the maximum working speed can be set by turning the speed potentiometer (fig. B, ref.
18).
•
If the machine is fitted with side brushes, these must be lowered using the levers on
the steering column. The brush motors will not start unless the brushes are fully
lowered (fig. R, ref. 1).
•
Begin working.
•
•
If the machine is fitted with the optional CHEM DOSE accessory, press the button (fig.
B, ref. 17) to turn the device on, then adjust the detergent mixture to send to the
