Diamond ICE32A, Инструкция по установке, эксплуатации и обслуживанию

Страница: 12 / 48

Once the appliance has been correctly connected to the electricity mains, water mains and water drain
system, it can be started up as follows:
a) turn on the water supply tap (8 in Fig. 4)
b) insert the plug (if any) in the socket and switch on the power supply by means of the relative switch
fitted during the installation phase (7 in Fig. 4)
Switch on appliance by pressing the luminous switch (16 in Fig. 3).
For appliances that are connected permanently to the electricity mains, turn on by means of the switch
on the outside of the appliance, fitted during the installation phase.
6.2.a STARTING UP MODELS WITH CONTINUOUS DELIVERY (Fig. 9)
Carry out operations a) and b) described above; then:
• remove the plug (17) on the front grille panel
• using a screwdriver turn the adjusting screw of the timer clockwise until you hear a click and the
water pump stops
• repeat the previous operation three times consecutively at intervals of one minute each
• when this operation has terminated, fit the plug (17) back on the front grille; the appliance will
automatically start producing ice
7 MAIN CAUSES OF OPERATING FAILURE
Should the appliance fail to produce ice, before calling on the Authorized Technical Service Centre, first
check carefully that:
• the water supply tap (8 in Fig. 4), fitted during the installation phase, has been turned on
• electric power is reaching the appliance; the plug (if any) is properly inserted in the socket, the switch
(7 in Fig. 4) is in the “ON” position, and the push button (16 in Fig. 3) is lighted up
Furthermore:
• if there is excessive noise, make sure that the appliance is not touching furniture or sheet metal which
can give rise to noise or vibrations
• should any trace of water appear, check the drain hole of the container to ensure that it is not clogged,
that the water fill and drain pipes are correctly connected and are not throttled or damaged
• make sure that the temperature of the air or water does not exceed the installation limit values
(see paragraph 5.2)
• make sure that the water inlet filter is not clogged (see paragraph 9.1)
• make sure that the spray nozzles are not clogged with scaly deposits
If the fault still persists after the above inspections have been made, turn off the electric power source
by means of the switch fitted during the installation phase, pull out the plug from its socket, turn off the
tap connecting the appliance to the water mains, and contact the nearest Authorized Technical Service
Centre.
To obtain a faster and more efficient reply when you call the Centre, state the model of the appliance
precisely, together with its serial number or manufacturing number. This information is given on the
serial N° plate (Fig. 1) affixed to the rear of the appliance and on the cover of this instruction manual.
8 OPERATION
The appliance has a thermostat probe in the ice bin, which stops ice production when the ice
accumulated in the bin reaches the probe connected to the thermostat.
When ice is taken from the bin, the thermostat will automatically reactivate ice-cube production, thus
creating a new supply of ice.
8.1 MODEL WITH CONTINUOUS DELIVERY (Fig. 10)
The appliance is equipped with an ice-cube dispenser (18) on the front.
To take the required quantity of ice, place a glass or a suitable container under the dispenser and press
the button (19) to turn on the supply.