E100301X rev5
21/02/14
seconds the display will show the drying
parameters.
Program parameters visualisation may be
anticipated or deleted using the ENTER
◄┘
Key.
Here below the parameters description:
The parameters shown above on the left are the
drying cycle temperature and length. In our
example the cycle will reach a maximum
temperature of 70°C and will be 50 minutes long.
The ending part of a drying program is a not
heated cycle (called cooling) which is necessary
to assure the integrity of the garments. The box
on the above pictures marks cooling temperature
and the cooling cycle time. The machine will
complete the cycle as soon as one of this two
parameters is reached. In the above example the
cooling cycle will be ended within 5 minutes or the
temperature is lower than 30°C.
In the above picture the drying heating power is
marked (only in case of machine equipped with
the power control option). The dry heating power
are three:
-
level 1: minimum power
-
level 2: medium power
-
level 3: maximum power
the level must be selected according to the kind of
fabric to be dryed. Higher is the selected level,
quicker will be the temperature increasing inside
the drum.
In the above picture the red box marks the drum
rotation speed (only in case of machine equipped
with the DSC option).
In the above picture the red box marks the fan
rotation speed (only in case of machine equipped
with the FSC option). Suction speed levels are
four:
-
level 1: very low speed
-
level 2: low speed
-
level 3: medium speed
-
level 4: high speed
The selected level correspond to the air passage
speed inside the drum: higher is the selected
level, quicker is the air passage inside the drum.
When the wished program is displayed, press the
START/PAUSE key to start it.
ATTENTION!
For a correct ironing cycle, the selected program
should assure a 10 – 20 % of linen residual
humidity at the end of the cycle.
ATTENTION!
In case of damages or working anomalies,
shut off the dryer and call the authorized
service centre.
ATTENTION!
At the end of the program the line must never
be left inside the stopped machine: you may
run into a phenomenon of auto combustion!
21. PROGRAM DELAYED START
To select the program follow the instructions given
in the previous paragraph, but instead to press
