Dialogic 1000Series, Руководство пользователя

Страница: 285 / 326

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 285
Diagnostics
9.3.1.3 Capabilities
The ability to route calls and send message waiting status updates through a particular PBX
interface and channel is determined by the capabilities, enabled state, and if the interface and
channel is in-service. If the interface and channel is not in-service or is not enabled, or it does not
support the capability for the requested action, then the interface and channel will not be used for
routing through the gateway and will not be included in a diagnostic test.
To view and modify the capabilities and enabled state on a PBX interface and channel navigate to
the
Gateway -> Gateway Capabilities Web page on the Media Gateway.
9.3.1.4 Location
The TDM self verification diagnostic tool is only part of the suite of diagnostic utilities that can be
used to assist in recording, testing, and resolving configuration or compatibility issues.
The Media Gateway diagnostic utilities are accessible via the Web interface by selecting the
Diagnostics link on the left side menu of any Web page.
9.3.2 TDM Self Verification Test Operation
To operate the TDM self verification diagnostic tool, the user must first navigate to the
Tests --> TDM Self Test link via the Media Gateway’s user interface.
In the TDM Self Verification Test Configuration table:
1. Choose the diagnostic test to perform by selecting one of the options in the Test Selection
field. The default selection is the Initiate Call / Answer Call diagnostic test only, but all
diagnostic test calls can be selected to be executed as one operation.
2. If the Initiate Call / Answer Call or Transfer Call diagnostic tests are selected, fill in the
interface extension numbers of the interfaces that are to be included in the test.
• Initiate Call / Answer Call - Requires two valid interface extension numbers.
• Transfer Call - Requires three valid interface extension numbers and is executed with
the Initiate Call / Answer Call diagnostic test.
3. If the Send Message Waiting Status diagnostic test is selected, fill in the Message Waiting
Extension Number field with the extension to send the status update requests.
Note: The Send Message Waiting Status diagnostic test does not allow individual interfaces
to be selected for inclusion/exclusion. The test will be executed on all available PBX
interfaces.
4. Select the Test Mode to be Sequential or Simultaneous (this is an optional parameter for
the test) .
Note: The Send Message Waiting Status diagnostic tests are always executed in Sequential
mode due to possible load issues of the PBX under test.
To start the specified diagnostic test, press the Start Test button on the Web page.
Note: Executing the TDM interface diagnostic tool temporarily disables gateway functionality. Any
active connections will be released.