Serial Commands
D
VS-05 Smart Camera Guide
D-5
OFFLINE
Stops all inspections.
TRIGGER {inspection index}
Triggers inspection. If {inspection index} is omitted, inspection 1 is
triggered.
VT (Virtual Trigger) Command
Triggers an inspection by pulsing a Virtual I/O point. For example:
VT 1
will return pulse
VIO1
. The inspection will run if it is configured to use
VIO
1
as a trigger.
Syntax: VT [VIO Index]
•
If specified, the VIO index must be in the allowed range for Virtual I/O
points within VisionScape. The virtual I/O line will be set high then
low.
•
If VIO Index is not specified, VIO1 is assumed
Success Return:
Nothing is echoed on success of the VT command.
Fail Return:
Return
!ERROR
followed by the reason for the failure. For
example:
!ERROR No such trigger
JOBSAVE [-slot=]n
Save job to slot
n.
JOBLOAD [-slot=n][-r]
Load job from slot
n
.
-r = Start inspections.
Содержание VS-05
