Dhollandia DH-P1, Руководство по эксплуатации, Страница: 27 / 48

26
DHOLLANDIA
be secured in the upright position.
 Make sure the platform surface is clean and can be accessed safely. Remove any snow, mud, dirt, debris, or slippery
liquids. Make sure you wear safety-toe shoes with a good non-slip sole.
 Check the lift cylinders for visible oil leaks. Follow the hydraulic pipes and fittings to the power pack. Make sure all wires
and hydraulic pipes are undamaged, not pinched or chafed anywhere, and adequately secured with cable ties. Check for
visible oil leaks.
Perform all movements several times with an unloaded platform with all available control units. Use the operating
instructions in section 8 for guidance.
 Make sure all movements occur smoothly and quietly, without jerking motion or unusual noises. The functions DEPLOY –
DOWN are based on gravity and shouldn’t produce any significant noise. The function UP – STOW use the hydraulic power
pack, the hydraulic motor and pump are audible during these functions.
Remember: if any part of the pre-trip inspection reveals a need for service or repair

DO NOT use the lift until it has been serviced or repaired by a qualified service technician.

Switch OFF power at the main battery disconnect switch or cabin switch
7.7 IMPORTANCE OF PREVENTATIVE MAINTENANCE
NOTICE

Competent and regular preventative maintenance is essential to the operational reliability of the lift as well as the safety of the
operator and all bystanders.

All maintenance and repair work must be performed by authorized DHOLLANDIA service agents and using original
DHOLLANDIA replacement parts only.

Please consult the separate MAINTENANCE AND REPAIR MANUAL for specific instructions regarding periodic maintenance.

If a lift cannot be repaired immediately in case of breakdown, it must be put out of operation and secured against unauthorized
use.

If required, use the emergency procedures of section 9 on page 39 to manually stow the platform in its travel position. If this
doesn’t go smoothly, do NOT apply brutal force as this might cause physical damage to the lift.

Avoid using the help of external devices (forklift, gantry crane, etc.) to stow a lift back in its travel position. When doing so, the
platform will not be supported by its hydraulic cylinders. When trying to deploy it again, the platform will drop in free fall, without
any possibility to stop the fall by means of the regular controls.
WARNING
Incorrect handling in case of a breakdown, or impact by a falling platform, can result in serious bodily injury
or death. To reduce the risk of injury:

Close the platform lock and apply additional means to immobilize the platform (ratchet straps, hoists
etc.).

Attach a clear and highly visible warning to the platform and the external control box.

Warn your supervisor and have the vehicle put out of service.

Contact an authorized DHOLLANDIA service agent to repair the lift prior to any further use.

To re-open the lift, use again an external device (forklift, gantry crane, etc.) for additional support. Or repair the breakdown first,
bring the hydraulic system under pressure and release the platform locks after satisfactory testing of the hydraulic integrity.
Follow the MAINTENANCE AND REPAIR MANUAL for all maintenance and repair works.