Dhollandia DH-P1, Руководство по эксплуатации, Страница: 28 / 48

27
DHOLLANDIA
8 OPERATING INSTRUCTIONS – PRINCIPLES AND PROCEDURES
8.1 CONTROL UNITS

The following types of controls are used on the DH-P* lifts
8.1.1 Standard 2-button wander lead with spiral cable (ref. OAE001)

This control unit has 2 buttons to control the functions DEPLOY – UP – DOWN - STOW.

Press DEPLOY to open the platform. When pressing the DEPLOY button, the platform will first deploy from the vertical travel
position to the horizontal work position, then continue down to the ground. When pressing the UP button, the platform will first
raise from the ground to the vehicle floor. The platform will stop at the vehicle floor if the platform is loaded and the UP button
released upon arrival. The platform will continue to close (= STOW) if the platform is empty and the UP button kept activated.

Operation:
8.1.2 Optional 3-button wander lead with spiral cable (ref. OWE002)

This control unit is standard on DH-PH2* wheelchair lifts, it is optional on the other DH-P*lifts.

It has 3 buttons to control the functions DEPLOY – UP – DOWN – STOW, and works in conjunction with an electrical end stop
on the lift arm (see # 7 in section 6.2 on page 12).

Operation: Press DEPLOY to open the platform. When pressing the DOWN button, the platform will first deploy from the vertical
travel position to the horizontal work position, then continue down to the ground. When pressing the UP button, the platform
will first raise from the ground to the vehicle floor and take a safety stop. Press the 2 upper buttons to close the platform in its
travel position (= STOW).

Operation: