Dhollandia DH-L 3300 lbs, Руководство по установке, Страница: 23 / 82

22
DHOLLANDIA
7.4 METHOD WITH HORIZONTAL PLATFORM
•
This method is recommended only when the platform can’t stand directly behind the rear frame of the body, or behind the rear doors.
See also 6.3.2 on page 18.
•
Determine the distance where the platform should stop behind the rear cross member. Prepare a corresponding spacer d [see below]
to insert between the rear cross member and the platform during installation.
•
Mount 2 tubes over the inboard platform edge, that overlap the vehicle floor by minimum 20” ( 500 mm).
•
Position the platform with the 2 tubes on the vehicle floor. Slide the required spacer between the rear cross member and the platform.
•
Secure the platform and prevent it from falling (by means of an overhead crane, hoists, forklift with slings, etc.)
•
Centre the platform in the door aperture.
•
Make sure the platform is parallel and level with the vehicle floor.
•
The gap between the rear cross member of the vehicle floor and the inboard platform edge will need to be covered by a bridge plate
or other techniques. See also 6.3.2 on page 18.
WARNING
•
The platform is very heavy! When falling on a person it can cause serious personal injury or death.
•
Therefore, handle the platform with extreme care. Use adequate lifting aids such as a forklift with slings, a gantry crane, hoists
etc. to secure the platform and prevent it from falling.