Dhollandia DH-L 3300 lbs, Руководство по установке, Страница: 14 / 82

13
DHOLLANDIA
•
Compare the maximum installation parameters indicated in these sources with the actual vehicle dimensions. If the actual dimensions
go outside of the maximum installation parameters, DON’T continue and contact your national DHOLLANDIA distributor for furthe r
advice.
•
The applicable mounting height mfc is given in the INSTALLATION DRAWING, or can be calculated by means of the following formula:
Example: For vehicle with 1250 mm floor height → mounting height mfc = ( 49” – 5.5” ) / 2 = 21 ¾”
•
Deviation is allowed as long as the maximum installation parameters vfh, mfc, mcg are respected.
NOTICE
•
When determining the installation dimensions, ALWAYS make sure to respect the maximum installation parameters vfh, mfc, mcg .
•
Study the image below explaining how mfc and mcg are correctly measured.
•
ALWAYS make sure you comply with applicable bumper bar regulations and observe the required dimensions lbug, lbup .
•
The mounting height mfc is measured from the top of the vehicle floor to the center of the lift arm. The image below shows how this
is measured for liftgates with a hydraulic auto-tilt at ground level (DH-LE* / LSP*) and mechanical auto-tilt at ground level (DH-LM*).
•
The required overhang lof / lop varies in function of the arm length larm and the chosen mounting height mfc . Refer to the POCKET
GUIDE (paper or App) for minimum overhang values (at mfc max ) and maximum overhang values (at mfc min ).
•
The arm width lac determines the body dimensions bci, bcw and blb ( see below).
mounting height mfc =
vehicle floor height vfh – 5.5”
2