47
ST102-CS
www.dfi.com
USB Power Control
Configure USB port power voltage.
USB3_1/2/3/4&USB2_5/6/7/8
Select the power voltage for USB 1-8 — 5V_Dual or 5V.
Network Stack Configuration
This section is used to configure the Network Stack settings.
Network Stack
This section is used to enable or disable UEFI network stack. When Network
Stack is enabled, the following fields will appear.
Ipv4 PXE Support
Enable or disable IPv4 PXE boot support. If disabled, IPv4 PXE boot support will
not be available.
Ipv6 PXE Support
Enable or disable IPv6 PXE boot support. If disabled, IPv6 PXE boot support will
not be available.
PXE boot wait time
Set the wait time in seconds to press ESC key to abort the PXE boot. Use either
+/- or numeric keys to set the value.
Media detect count
Set the number of times the presence of media will be checked. Use /-
or numeric keys to set the value.
5V_Dual: Support system
wake up from S3/S4 by
USB KB&MS
5V: No support system
wake up from S3/S4 by
USB KB&MS
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
USB3_1/2/3/4&USB2_5/6/7/8
→←:
Select Screen
↑↓:
Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
[5V_Dual]
Advanced
Enable/Disable UEFI
Network Stack
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Network Stack
Ipv4 PXE Support
Ipv6 PXE Support
PXE boot wait time
Media detect count
→←:
Select Screen
↑↓:
Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
[Enabled]
[Disabled]
[Disabled]
0
1
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Advanced