13
ST102-CS
www.dfi.com
Installing a Memory Module
The system board is equipped with two memory slots. Please use the following procedure to
install SODIMM modules.
Grasp the module by its edges and align the memory’s notch with the socket’s notch; then in-
sert the memory into the socket at an angle and push it down until you feel a click.
Notes:
1. The system supports dual-channel configuration. To enable dual-channel,
populate both SODIMM sockets.
2. If installing only one memory module, please install it on the memory socket
labeled DIMM 1 (the one closer to the center of the board).
3. The SODIMM sockets can only accommodate DDR4 memory modules. Please
do not install other types of memory modules.
4. Place the SATA drive bay back in the chassis and install the SATA drive bay using the
mounting screws you removed in step 1.
5. Connect the SATA data/power cable to the SATA drive (refer to the above picture). Make
sure the other end of the SATA data/power cable is connected to the connectors on the
system board (refer to the picture below).
Mounting screw
SATA power/
data cable
SATA data
connector
SATA power
connector
DIMM1
DIMM2