18
ST102-CS
www.dfi.com
RJ45 LAN Ports
USB Ports
The two LAN ports allow the system board to connect to a local area network with a network hub.
BIOS Setting
Configure the onboard LAN ports in the Advanced menu (“ACPI Configuration” submenu) of the
BIOS. Refer to Chapter 7 - BIOS for more information.
Driver Installation
Install the LAN drivers. Refer to Chapter 8 - Supported Software for more information.
Features
• LAN 1: Intel
®
I211AT PCIe (10/100/1000Mbps)
• LAN 2: Intel
®
I219V/LM (10/100/1000Mbps)
USB 2.0
USB 6
USB 2.0
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The motherboard is equipped with 4 onboard USB Type A ports (USB 1-2/3-4) at the rear
panel I/O ports. The four USB rear ports support USB 3.1 Gen 1 on CS101-H310, and USB 3.1
Gen 2 on CS101-Q370/C246. Two 10-pin USB internal connectors allow you to connect to 4
additional USB 2.0 ports (USB 5-6/7-8)
The additional USB ports may be mounted on a card-edge bracket. Install the card-edge
bracket to an available slot on the system chassis and then insert the USB port cables to a
connector.
USB 7-8
10
VCC
-Data0
+Data0
GND
VCC
-Data1
+Data1
GND
N.C.
9
1
2
USB 5
Activity/Link LED
Speed LED
LED Behavior
Description
LED Behavior Description
Off
No link
Off
10Mbps connection
Blinking
Data Activity
Green
100Mbps connection
On
Link
Orange
1Gbps connection
LAN 1
LAN 2
LAN 1
LAN 2
USB 2
USB 1
USB 4
USB 3
USB 3.1 Gen 1
USB 2
USB 1
USB 4
USB 3
USB 3.1 Gen 2
▲
CS101-H310
▲
CS101-Q370/C246