PCI/ISA System Board
Then reboot the system.
DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN
SETUP
Type of diskette drive installed in the system is different
from the CMOS definition. Run setup to reconfigure the
drive type correctly.
DISPLAY SWITCH IS SET INCORRECTLY
Display switch on the motherboard can be set to either
monochrome or color. This indicates the switch is set to
a different setting than indicated in Setup. Determine
which setting is correct, and then either turn off the
system and change the jumper, or enter Setup and
change the VIDEO selection.
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT
Since last powering off the system, the display adapter
has been changed. You must configure the system for
the new display type.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialized. Be sure the adapter is
installed correctly and all cables are correctly and firmly
attached. Also, be sure the correct hard drive type is
selected in Setup (refer to Appendix G).
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the card is
correctly and firmly installed in the bus. Be sure the
correct hard drive type is selected in Setup. Also, check
to see if any jumper needs to be set correctly on the
hard drive.
B-2
u
Appendix B
Содержание G586OPB
Страница 1: ...G586OPB Rev 0 SystemBoard User sManual D27850601...
Страница 104: ...G586OP A Rev 0 SystemBoard User sManual...
Страница 105: ...G586OP A Rev 0 SystemBoard User sManual 27850601...
Страница 106: ...G586OP A Rev 0 SystemBoard User sManual...
