
www.dfi .com
Chapter 3 Hardware Installation
29
Chapter 3
8. From the bottom of the board, fasten the provided bolt into the screw and then connect
the heat spreader/heat spreader with heat sink and fan’s cable to the fan connector on
CM960-B.
9. Grasping CM960-B by its edges, position it on the top of the carrier board with its
mounting holes aligned with the bolts on the carrier board. This will also align the COM
Express connectors of the two boards to each other.
COM Express connectors on
CM960-B
11. Use the provided mounting screws to secure CM960-B with heat sink to the carrier board.
The photo below shows the locations of the long mounting screws.
10. Press CM960-B down firmly until it is completely seated on the COM Express connectors of
the carrier board.
Fan connector
COM Express connectors
on the carrier board
Carrier board
CM960-B
Long screws
Содержание CM960-B
Страница 1: ...www dfi com Chapter 1 Introduction 1 CM960 B COM Express Basic Module User s Manual A32100420...
Страница 62: ...www dfi com Chapter 5 Supported Software 62 Chapter 5 WatchDog DIO Backlight...
Страница 76: ...www dfi com 76 Appendix E Appendix E BIOS Status Code PEI Beep Codes DXE Status Codes...
Страница 77: ...www dfi com 77 Appendix E Appendix E BIOS Status Code...