
www.dfi .com
Chapter 3 Hardware Installation
12
Chapter 3
System Memory
DDR3_2
Standby
Power LED
The system board is equipped with two 204-pin SODIMM sockets that support DDR3 up to
16GB system memory.
DDR3_1
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.
Important:
When the Standby Power LED lit red, it indicates that there is power on the system
board. Power-off the PC then unplug the power cord prior to installing any devices.
Failure to do so will cause severe damage to the motherboard and components.
Содержание CM960-B
Страница 1: ...www dfi com Chapter 1 Introduction 1 CM960 B COM Express Basic Module User s Manual A32100420...
Страница 62: ...www dfi com Chapter 5 Supported Software 62 Chapter 5 WatchDog DIO Backlight...
Страница 76: ...www dfi com 76 Appendix E Appendix E BIOS Status Code PEI Beep Codes DXE Status Codes...
Страница 77: ...www dfi com 77 Appendix E Appendix E BIOS Status Code...