
www.dfi .com
Chapter 3 Hardware Installation
27
Chapter 3
Installing CM960-B onto a Carrier Board
• To download COM331-B datasheet and manual
Important:
The carrier board (COM331-B) used in this section is for reference purpose only and
may not resemble your carrier board. These illustrations are mainly to guide you on
how to install CM960-B onto the carrier board of your choice.
1. Use the provided screw to install the heatsink onto the module. First align the mounting
hole of the heatsink with the mounting hole of the module and then from the bottom
side of the module, secure them with the provided screw. The module and heatsink
assembly should look like the one shown below.
Mounting hol
e
Mounting hole
Bottom side of heat sink
Mounting
screw
Top view
Bottom view
Top view
2. Now install the module and heatsink assembly onto the carrier board. The photo below
shows the locations of the mounting holes on the carrier board.
3. Insert the provided mounting screws into the mounting holes - from the bottom through
the top of the carrier board.
Mounting hole
Mounting screws
Содержание CM960-B
Страница 1: ...www dfi com Chapter 1 Introduction 1 CM960 B COM Express Basic Module User s Manual A32100420...
Страница 62: ...www dfi com Chapter 5 Supported Software 62 Chapter 5 WatchDog DIO Backlight...
Страница 76: ...www dfi com 76 Appendix E Appendix E BIOS Status Code PEI Beep Codes DXE Status Codes...
Страница 77: ...www dfi com 77 Appendix E Appendix E BIOS Status Code...