59
3
Award BIOS Setup Utility
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
The system will automatically select an I/O address for
the onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Allows you to
manually select an I/O address for the onboard serial
port 1 and serial port 2.
Disabled
Disables the onboard serial port 1 and/or serial port 2.
UART 2 Mode
The system board supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J21) and the COM 2 serial port (J6) at the same time. If you
are using the COM 2 serial port, make sure this field is set to
Standard.
To use the IrDA function, follow the steps below.
1. Connect your IrDA cable to connector J21 on the system
board.
2. Set the UART 2 Mode field to the type of IrDA standard
supported by your IrDA peripheral/device (HPSIR or ASKIR).
For better transmission of data, your IrDA peripheral device
must be within a 30
o
angle and within a distance of 1 meter.
3. Set the IR Function Duplex and TX,RX Inverting Enable fields
appropriately.
IR Function Duplex
Half
Data is completely transmitted before receiving data.
Full
Transmits and receives data simultaneously.
TX,RX Inverting Enable
The options are No, Yes; Yes, No; Yes, Yes; No, No.
Содержание CA63-EN
Страница 1: ...CA63 SN CA63 EN Rev A System Board User s Manual 45210041...
Страница 13: ...2 Hardware Installation 13 2 1 System Board Layout Chapter 2 Hardware Installation CA63 SN VIA 82C693A 82C686A...
Страница 14: ...2 14 Hardware Installation CA63 EN VIA 82C693A 82C686B...
Страница 21: ...2 Hardware Installation 21 2 3 On Clear CMOS Data 1 2 On Normal default 1 2 3 1 2 3 8 Type Y and press Enter...