Dexter Laundry T-300 VENDED, Руководство оператора: инструкции по установке и эксплуатации

Страница: 41 / 55

8514-302-001 REV B page 41
COIN WASHER DEFAULT CYCLE
The following table shows the complete details for the coin washer default cycle.
Bath
Bath Cycle
Time (min.)
Water
Temp.
Delay Fill Spin Time
(min.)
Prewash 0 Cold Off 0
Wash 9 Warm Off 0
Extend Wash 0 n/a n/a n/a
Rinse 4 Cold Off 1
Final Rinse 5 Cold Off n/a
Extra Rinse Spin n/a n/a n/a 0
Extra Rinse Bath 0 Cold Off n/a
Final Extract Spin n/a n/a n/a 6
WASHERS WITHOUT COIN ACCEPTORS
If you purchased a washer without a coin acceptor and are installing a payment device
of your choice, refer to the washer wiring diagram for proper connection. You may also
need to contact the payment device supplier for additional information.
RAPID ADVANCE MODE
Rapid Advance mode may be manually entered by pushing and holding the Cold water
temperature button and then pushing and holding the programming button on the
controller for three seconds. There will be no observed change to the washer or the
display. The Rapid Advance mode can be entered from either the Idle mode or during
the cycle. To rapid advance to the next step in the wash cycle, push the start button.
The display will show “ADVANCE”. The washer will advance to the next bath segment.
The water will drain before the advance will occur.
The Rapid Advance mode will not end until the final bath segment is completed. The
final segment cannot be skipped in Rapid Advance mode.
Notes: 1. When the Rapid Advance mode is used, the cycle time will no longer be
correct.
2. By skipping steps with rapid advance, the door may not open immediately at
the end of the cycle.