Dexter Laundry T-300 VENDED, Руководство оператора: инструкции по установке и эксплуатации

Страница: 13 / 55

8514-302-001 REV B page 13
4)
Mix non-shrinking machinery grout according to the grout
instructions. The grout should not be too runny or too firm.
Completely fill the 1/2” [12.7] space between the washer base and the
mounting surface. Force grout under all base angles and plates until
completely filled. Fill around all anchor bolts.
5)
Finger tighten all nuts to anchor bolts.
6)
When the grout has started to stiffen (but before it is cured),
remove the spacers from the corners and allow the washer to settle
into the wet grout. Fill in any voids as necessary with additional grout.
7)
Allow grout to completely cure, then tighten all nuts to securely
fasten the washer to the grouted mounting surface.
8)
Retighten nuts after 5 days of operation and check quarterly.
If using a steel mounting base, first grout the steel mounting base to the
concrete floor using the above steps, then repeat the steps for mounting
and grouting the washer to the steel mounting base.
FLOOR LOAD DATA
Model
Dry Weight
Capacity
(lb [kg])
Extract
Speed
(RPM) Extract G-
Force
Maximum
Static Load
(lb [kN])
Static Load
Pressure
(lb/sq ft
[kN/ sq m])
Total
Dynamic
Load (lb
[kN])
Dynamic
Load
Pressure
(lb/sq ft
[kN/ sq m])
Dynamic
Load
Frequency
(Hz)
Maximum
Vertical
Load (lb
]kN])
Maximum
Moment About
Washer Base
(ft*lbs [m-kN])
T-300 23 [10.5] 550 90 384 [1.7] 91 [4.4] 416 [1.9] 99 [4.7] 9.2 756 [3.4] 816 [1.1]
T-350 23 [10.5] 777 180 450 [2.0] 94 [4.5] 832 [3.7] 174 [8.3] 13.0 1238 [5.5] 1633 [2.2]
T-350 SWD 23 [10.5] 777 180 867 [3.9] 128 [6.1] 832 [3.7] 123 [5.9] 13.0 1655 [7.4] 1633 [2.2]
Note:
DEXTER DYNAMIC LOADING CHART
The out-of-balance loading conditions may very dependent on load size and
material.