Dexter Laundry 900RPS2-200.5, Инструкция по эксплуатации

Страница: 49 / 58

36
,;
EN
7. Maintenance
a)
Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tight-
ened. Should any of the screws be loose, tighten them immediately. Failure to do
so could result in serious injuries.
b) Maintenance of the motor
The motor unit winding is the very “heart” of the power tool. Exercise due care to
ensure the winding does not become damaged and/or wet with oil or water.
c) Inspection the carbon brushes
The motor employs carbon brushes which are consumable parts. Since an exces-
sively worn carbon brush could result in motor trouble, replace the carbon brush
with an identical part when it becomes worn to or near the limit. In addition,
always keep carbon brushes clean and ensure that they slide freely with in the
brush holder
.
d)
Maintenance the supply cord
This supply cord is type Y attachment, method of attachment of the supply cord
such that any replacement is intended to be made by the manufacturer, its service
agent or similar qualified person.
If a set of spare carton brush is included in this package for replacement purposes.
The check and replacement of the brushes should only be performed by a qualified
service technician using identical parts to ensure the integrity of double insula-
tion. To assure the safety of our customers, we strongly recommend against the
consumers checking and changing the brushes.
Under normal usage, the carbon brushes will last beyond the 90 day warranty
period. Therefore, do not open the body housing within 90 days of purchase to
inspect the brushes or the manufacturer warranty will void at that time, please see
warranty section if a return is necessary.
Do not allow brake-fluids, gasoline, petroleum-based
products penetrating oils, etc. Come in contact with plastic
parts. They contain chemicals that can damage, weaken or destroy the
housing, thus compromising the integrity of the double insulation.
WARNING
FR
ES
PT
IT
PL
UA
RU
RO
GR
EN
166
8. Trouble shooting
1. Replace the saw blade according to which material to cut, as soon as its teeth
are blunt and proper sawing is therefore no longer possible.
2. Clean the appliance after completing your sawing work.
3. Remove any dirt (e.g. sawdust). If necessary, clean the saw blade mounting
with a brush or blow it out with compressed air.
7. Maintenance
Please read “WARNING” or previous section regarding check-
ing and changing of the SAW BLADE.
WARNING
Problem
Possible cause Solution
Product does not start
Not connected to power supply Connect to power supply
Power cord or plug is defective Check by a specialist
electrician
Other electrical defect to the
product
Check by a specialist
electrician
Product does not reach
full power
Extension cord not suitable for
operation with this product
Use a proper extension
cord
Power source(e.g.generator)has
too low voltage
Connect to another power
source
Air vents are blocked Clean the air vents
Unsatisfactory result
Blade is worn Replace with new blade
FR
ES
PT
IT
PL
UA
RU
RO
GR
EN
167