DewertOkin SIRIUSi-XHS, Техническое справочное руководство

Страница: 42 / 52

SIRIUSi-XHS®
TECHNICAL REFERENCE MANUAL
5. Real-time controller - XCP slave settings
With the SIRIUSi-XHS® device, data can be run in parallel over the XCP protocol, when the device is
connected in Run-time mode over Ethernet. Follow the instructions written in chapter
2.2.3.
DewesoftX® settings for SIRIUSi-XHS® , to properly connect and set the device.
The XCP settings must be specified in Dewesoft software and properly uploaded to the device. When
the settings are done and the RT-mode is properly started, Dewesoft can be closed. The maximum
sample rate for data transmitted over the XCP protocol is 1Mhz.
5.1. XCP-Slave module settings
The Real-time controller module is added in the Channel setup the same way as any other module. If
the module can not be selected, you need to re-check in settings if the RT device is properly configured
and recognized.
Image 53: Adding RT controller module
When you enter the Module the following settings will appear. If multiple RT devices are connected, a
separate tab will be created for each one
❶
.
SIRIUSi-XHS® - V21-2
42/52