DeWalt XR Li-Ion DCS355-XE, Инструкция по эксплуатации

Страница: 11 / 16

9
INSTALLING/REMOVING SANDING SHEETS (FIG. 6)
A diamond shaped platen uses a hook and loop
adhesion system to attach the sanding sheets.
The platen allows you to use it on large flat
surfaces and tight spots or corners.
1. Attach the sanding platen (K) as described
under Installing/Removing Accessories .
2. Align the edges on the sanding sheet, with
the edge of the sanding platen and press the
sanding sheet (L) onto the platen.
3. Firmly press the base with the sanding sheet
attached against a flat surface and briefly
switch the tool on. This provides for good
adhesion between the platen and the sanding
sheet and also helps to prevent premature
wear.
4. When the tip of the sanding sheet becomes worn, detach the sheet from the
platen, rotate and reapply.
ATTACHING ACCESSORIES USING THE UNIVERSAL ADAPTER (FIG. 7)
Non-D
E
WALT accessories can be attached using the universal adaptor.
1. Place the washer (M) on the tool.
2. Place accessory on to washer.
3. Tighten and secure adaptor nut (N) using
hex wrench.
CAUTION: To avoid injury, do not use any
accessory for an application where the adaptor
may fail to hold the accessory.
CAUTION: Read and follow all manufacturers'
safety warnings for any accessories used with
this tool.
CAUTION: To avoid injury, ensure adaptor and accessory are securely tightened.
FIG. 6
L
K
FIG. 7
M
N
Attaching the Cut/Depth Guide (Fig. 8–12)
(AVAILABLE IN SELECTED MODEL ONLY)
The cut/depth guide allows you to precisely cut material
at a specified depth or height and more accurately track
a marked cut line.
1. Attach the cut guide block (F) by inserting the tabs
(O) on the guide into the accessory side mount (E)
on the main body of the tool.
2. Secure the block to the main body with the
supplied screw (Q) and washer (S). Tighten with
the supplied hex wrench (R).
DEPTH GUIDE
This feature allows you to precisely cut material at a
specified depth.
1. Insert the guide arm (G) as shown in Figure 9 into
the front slot on the guide block (F).
2. Adjust the length of the guide by pulling out or
pushing inward to achieve the desired cut depth as
shown in Figure 10.
3. Secure the guide in place by turning the depth/cut adjustment knob (P)
clockwise. To release the guide, turn the depth/cut adjustment knob
counterclockwise.
P
FIG. 9
FIG. 10
F
G
CUT GUIDE
This feature allows you to more accurately track a marked cut line.
1. Insert the guide arm (G) as shown in Figure 11 into the slots on the left and right
sides of the guide block (F).
E
O
Q
R
F
FIG. 8
S