DeWalt DW848, Руководство пользователя

Страница: 8 / 24

4 en - 4
E N G L I S H
7 Top hole
8 Side holes
9 Carbon brush covers
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D
E
WALT tool is double insulated in
accordance with EN 50144; therefore no
earth wire is required.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). An undersized cable will
cause a drop in line voltage resulting in loss of
power and overheating.
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
Minimum gage for cable sets
Voltage Total cable length in feet
120 0-25 26-50 51-100 101-150
240 0-50 51-100 101-200 201-300
Ampere rating
More than Not more than AWG
0-6 18 16 16 14
6-10 18 16 14 12
10-12 16 16 14 12
12-16 14 12 not recommended
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Mounting and removing the guard (fig. B)
• Place the Angle Grinder on a table, spindle up.
• Mount the guard to the tool using the three
screws (10) with star washers.
• Rotate the guard to the required position and
tighten the lock nut (11).
• To remove the guard, loosen the three screws (10).
Fitting and removing a grinding wheel or cutting
disk (fig. C)
• Place the tool on a table, guard up.
• Fit the spacer (12) correctly onto the spindle (5).
• Place the grinding wheel or cutting disk on the
spacer.
• Screw the threaded flange (13) onto the spindle (5).
• Press the spindle lock (4) and rotate the grinding
wheel or cutting disk until it locks in position.
• Tighten the threaded flange (13) with the two-pin
spanner supplied.
• Release the spindle lock.
• To remove the grinding wheel or cutting disk,
loosen the threaded flange (13) with the two-pin
spanner.
Fitting a wire cup brush
• Screw the wire cup brush directly onto the
spindle without the use of the spacer and
threaded flange.
Mounting the side handle (fig. D)
• For grinding, screw the side handle (6) tightly into
one of the holes (8) on either side of the gear case.
• For cutting, screw the side handle (6) tightly into
the top hole (7).
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the
grinding wheel or cutting disk.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the appropriate guard and disk or wheel.
Do not use excessively worn disks or wheels.
• Be sure the spacer and threaded flange are
mounted correctly.
• Make sure the disk or wheel rotates in the
direction of the arrows on the accessory and the
tool.