DeWalt DE0892-XE, Инструкция по эксплуатации

Страница: 5 / 8

3
ASSEMBLY AND ADJUSTMENTS
WARNING: Refer to the manual of the tool to be used with this attachment.
Batteries (Fig. 1)
The digital laser detector is powered by a 9-volt battery. To install the battery
provided, lift up on the battery compartment cover (C). Place the 9-volt battery in the
compartment, aligning the battery as shown on the embossed icon.
Detector Controls (fig. 1)
The detector is controlled by the power button (E) and the volume button (F).
When the power button is pushed once, the detector is turned on. The top of the
sensor window shows the ON icon and the volume icon.
The D
E
WALT Digital Laser Detector also has an auto shut-off feature. If a laser beam
does not strike the beam detection window, or if no buttons are pressed, the detector
will shut itself off in about 5 minutes.
To turn off the audible signal push the button again; the volume icon will disappear.
The detector powers up in the narrow accuracy setting (icon appears in the lower left
corner). Press the accuracy button (G) once to change to wide accuracy setting (icon
now appears in the lower right corner).
Accuracy
The detector provides two accuracy settings, wide and narrow. In the wide setting,
the detector provides a larger tolerance for indicating that the detector is “on grade.”
In the narrow setting, this tolerance is reduced for more accurate indication of “on
grade.”
For the most accurate results, start the work using the wide setting and finish in the
narrow setting.
Magnets
The magnets (H) allow the detector to be mounted to the metal tracks during the
installation of a suspended ceiling.
OPERATION
Instructions for Use
WARNING:
• Always observe the safety instructions and applicable regulations.
• Before first use, remove and discard the protective tape from the screens.
Detector Operation (Fig. 1)
1. Set up and position the laser.
2. Turn the detector on by pressing the power button (E).
3. Position the detector so that the sensor window (I) is facing the laser beam.
Move the detector up or down within the approximate area of the beam, until you
have centred the detector. For information about the display window indicators
and the audible signal indicators, refer to the table titled Indicators.
INDICATORS
Above
Grade
Slightly
Above
Grade
On
Grade
Slightly
Below Grade
Below
Grade
audible signals
fast
beep
fast
beep
steady
tone
slow
beep
slow
beep
display icons
4. Use the marking notches (D) to accurately mark the position of the laser beam.