10
NOTE:
The torque adjustment collar (E) may be set on
any number.
SCREWDRIVING (FIG. 4)
Rotate the mode control collar (F) so the screw symbol
is aligned with the arrow.
NOTE:
The torque adjustment collar may be set to any
number at any time. However, the torque adjustment
collar is only engaged during screwdriving mode and
not in drill and hammerdrill modes.
HAMMERDRILLING (FIG. 5)
CAUTION:
When the mode collar is in the drill/
hammerdrill mode, the drill will not clutch out regardless
of the position of the torque adjustment collar (E).
Three-Speed Gearing (Fig. 3–5)
The three-speed feature of your tool allows you to shift
gears for greater versatility. To select speed 1 (highest torque
setting), turn the tool off and permit it to stop. Slide the gear
shifter (G) all the way forward. Speed 2 (middle torque and
speed setting) is in the middle position. Speed 3 (highest
speed setting) is to the rear.
NOTE:
Do not change gears when the tool is running.
Always allow the drill to come to a complete stop before
changing gears. If you have trouble changing gears, make
sure that the gear shifter is engaged in one of the three
speed settings.
Chucks
WARNING:
Do not attempt to tighten drill bits (or
any other accessory) by gripping the front part of the
chuck and turning the tool on. Damage to the chuck and
personal injury may result. Always lock off trigger switch
and disconnect tool from power source when changing
acces sories.
WARNING:
Always ensure the bit is secure before
starting the tool. A loose bit may eject from tool causing
possible personal injury.
KEYLESS SINGLE SLEEVE CHUCK (FIG. 6–8)
DCD960-XE, DCD980-XE
Your tool features a keyless chuck with one rotating
sleeve for one-handed operation of the chuck. To insert a
drill bit or other accessory, follow these steps.
1. Lock the trigger in the OFF position. Turn off tool and
disconnect tool from power source.
2. Grasp the black sleeve of the chuck (D) with
one hand and use the other hand to secure the
tool as shown in Figure 6. Rotate the sleeve
counterclockwise (as viewed from the front) far
enough to accept the desired accessory.
FIG. 3
E
F
G
SCREWDRIVING
HAMMERDRILLING
DRILLING
E
F
G
FIG. 5
FIG. 4
Rotate the mode control collar (F) so the hammer
symbol is aligned with the arrow.
Torque Adjustment Collar (Fig. 3–5)
Your tool has an adjustable torque screwdriver mechanism
for driving and removing a wide array of fastener shapes
and sizes. Circling the torque adjustment collar (E) are
numbers. These numbers are used to set the clutch to
deliver a torque range. The higher the number on the
collar, the higher the torque and the larger the fastener
which can be driven. To select any of the numbers, rotate
until the desired number aligns with the arrow.
Содержание DCD950-XE
Страница 2: ......
