DeWalt D26204-XE, Инструкция по эксплуатации

Страница: 13 / 20

11
FIG. 9
V
W
FIG. 10
HH
II
KK
JJ
U
X
4. When using vacuum attachment, be aware of the placement of the vacuum
cleaner. Be sure that the vacuum cleaner is stable and that its hose will not
interfere with the work.
Vacuum Attachment (Plunge Base Only, Fig. 10)
1. Remove the motor unit from the plunge base. Refer to Motor Quick Release .
2. Slide tab (HH, inset) on vacuum attachment into slot (X) in plunge base and snap
tab (II, inset) into hole in plunge base.
3. Secure to base with supplied plastic washer (JJ) and thumb screw (KK). Tighten
thumb screw securely by hand.
4 Attach hose adaptor to vacuum attachment (U).
5. When using vacuum attachment, be aware of the placement of the vacuum
cleaner. Be sure that the vacuum cleaner is stable and that its hose will not
interfere with the work.
Set-up: Fixed Base
INSERTING THE MOTOR INTO THE FIXED BASE (FIG. 1, 2)
WARNING: To reduce the risk of injury, turn unit off and disconnect it from
power source before installing and removing accessories, before adjusting or
when making repairs.
An accidental start-up can cause injury.
1. Open the locking lever (I) on the base.
2. If the depth adjustment ring (B) is not on the motor (J), thread the depth
adjustment ring (B) onto the motor until the ring is about halfway between the
top and bottom of the motor as shown. Insert the motor into the base by aligning
the groove on the motor (G) with the guide pins (R) on the base. Slide the motor
down until the depth adjustment ring snaps into place.
NOTE: Guide pin grooves (G) are located on either side of the motor so it can be
positioned in two orientations.
3. Adjust the depth of cut by turning the depth adjustment ring. Refer to Adjusting
the Depth of Cut .
4. Close the locking lever (I) when the desired depth is achieved. For information on
setting the cutting depth, refer to Adjusting the Depth of Cut .