DeWalt D26204-XE, Инструкция по эксплуатации

Страница: 10 / 20

8
Excessive force should not be used to clamp the locking lever. Using excessive force
may damage the fixed base.
When the locking lever (I) is clamped the motor (J) should not move in the fixed base.
Adjustment is needed if the locking lever will not clamp without excessive force or if
the motor moves in the fixed base after clamping.
TO ADJUST THE LOCKING LEVER’S CLAMPING FORCE
1. Open the locking lever (I).
2. Using a hex wrench turn screw (S) in small increments.
NOTE: Turning the screw clockwise tightens the lever, while turning the screw
counterclockwise loosens the lever.
FIG. 5
S
I
Centering the Subbase (Fig. 1, 6)
WARNING: To reduce the risk of injury, turn unit off and disconnect it from
power source before installing and removing accessories, before adjusting or
when making repairs. An accidental start-up can cause injury.
If you need to adjust, change, or replace the subbase, a centering tool is
recommended. Refer to Accessories . The centering tool consists of a cone and a pin.
TO ADJUST THE SUBBASE
1. Loosen but do not remove the subbase screws (LL) so the subbase moves
freely.
2. Insert the pin into the collet and tighten the collet nut.
3. Insert the motor into the base and clamp the locking lever on the base.
4. Place the cone on the pin (T) and lightly press down on the cone until it stops as
shown. This will center the subbase.
FIXED BASE ASSEMBLED
Proper hand position requires one hand to be wrapped around the base as shown.
WITH PLUNGE BASE ASSEMBLED
Proper hand position when using the plunge base requires one hand on each of the
plunge handles (AA) as shown.
FIG. 4
AA
FIXED BASE PLUNGE BASE
Starting and Stopping the Motor (Fig. 1)
CAUTION: Before starting the tool, clear the work area of all foreign objects. Also
keep firm grip on tool to resist starting torque.
CAUTION: To avoid personal injury and/or damage to finished work, always allow
the power unit to come to a COMPLETE STOP before putting the tool down.
To turn unit on, depress the side of the dust-protected switch (D) that reads ON and
corresponds to the symbol “I.”
To turn the unit off, depress the side of the switch that reads OFF and corresponds
with the symbol “O.”
Locking Lever Adjustment, (Fixed Base Only, Fig. 1, 5)
WARNING: To reduce the risk of injury, turn unit off and disconnect it from
power source before installing and removing accessories, before adjusting or
when making repairs. An accidental start-up can cause injury.