DeWalt D26204-XE, Инструкция по эксплуатации

Страница: 8 / 20

6
.............. Class II Construction .............earthing terminal
................... (double insulated) ..............safety alert symbol
…/min ........ per minute BPM ..........beats per minute
IPM ............. impacts per minute RPM ..........revolutions per minute
SPM ............ strokes per minute sfpm ..........surface feet per minute
SAVE ALL WARNINGS AND INSTRUCTIONS FOR
FUTURE REFERENCE
COMPONENTS (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage or personal
injury could result.
A. Quick release tabs
K. Subbase (the round subbase and the
B. Depth adjustment ring D-subbase are available as an accessory)
C. Variable speed dial L. Collet nut
D. On/Off (I/O) switch M. Holes for premium parallel fence
E. Spindle lock button N. Turret stop
F. LED lights O. Depth adjustment rod
G. Guide pin groove P. Plunge lock lever
H. Micro adjustment scale Q. Motor stop
I. Locking lever R. Guide pins
J. Motor unit
INTENDED USE
Your heavy-duty compact router has been designed for professional heavy duty
routing of wood, wood products and plastics.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
These compact routers are professional power tools. DO NOT let children come into
contact with the tool. Supervision is required when inexperienced operators use this
tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Cutters
The tooling can be used with the complete range of commercial cutters (e.g: straight,
rabbet, profile cutter, slotter cutter or grooved knife) with the following technical data:
1. Shank diameter 6–6.35 mm
2. Cutter speed of min. 30000/min
WARNING: Max diameter to use:
• For straight cutters, rabbet cutters, profile cutters, the maximum shank diameter
MUST be 6.35 mm, the maximum diameter MUST be 36 mm, the maximum
cutting depth MUST be 10 mm.
• For slotter cutters, the maximum shank diameter MUST be 6.35 mm and the
maximum diameter MUST be 25 mm.
• For grooved knives, the maximum shank diameter MUST be 6.35 mm, the
maximum diameter MUST be 40 mm and the maximum cutting width MUST be 4
mm.
Motor Quick Release (Fig. 2)
FIG. 2
A
G
I
R
WARNING: To reduce the risk of injury,
turn unit off and disconnect it from power
source before installing and removing
accessories, before adjusting or when
making repairs. An accidental start-up can
cause injury.
1. Open the locking lever (I) on the base.
2. Grasp the motor unit with one
hand, depressing both quick release
tabs (A).
3. With the other hand, grasp the base
and pull motor from the base.