Devon 1107-26DE, Руководство пользователя

Страница: 13 / 28

Manual_Revised_V1.0 Page 12
(2 ) Insert the tool with a twisting motion into the
tool holder until it locks.
(3 ) The tool locks itself. Check the locking by
pulling on the tool.
2) Removing:
Pull the plastic sleeve to the rear, hold it in this
position and remove the tool from the tool holder.
6. INSERTING/REMOVING TOOL HOLDER
(1 ) Removal
Set the operating mode selector knob
temporarily to the “Chiseling” position (drill
spindle locked).
Turn the plastic sleeve firmly counterclockwise to
the stop and pull off the tool holder.
(2
) Mounting
Place the tool holder on the drill spindle.
Turn the plastic sleeve counterclockwise (to the
left) and simultaneously press back firmly until
the tool holder latches and locks. Ensure that
the tool holder sits tightly.
7. SETING THE GUIDE RULER
Release the auxiliary handle clamping
mechanism by turning the handle in a
counterclockwise direction. Pivot the auxiliary
handle into the desired position. Adjust the
guide ruler to the desired drilling depth” X “.
Tighten the auxiliary handle securely by turning
the handle in a clockwise direction.
8. SET THE OPERATING MODE
With the operating mode selector knob, select
the operating mode of the machine. To change
the operating mode , turning the operating mode
selector knob to the desired position until you
hear “click” to latch.
WARNING: Change the operating mode
only when the machine is switched off!
Otherwise, the machine can be damaged.
●
For drilling in steel or wood, for tighten the
screws.
●
For hammer drilling in concrete or ston e .