To change the velocity curve of the drum pads, press the Edit button and then press the Pad
Curve button. The LED screen will display the currently selected curve. The value can then
be adjusted between 01 and 06 using the transport section rotary knob. Confirm the
selection by pressing the Enter button.
Pad Note Setting
To specify the MIDI note sent by a specific pad, press the pad and then press the Assign
button. Then, using the transport section rotary knob, the MIDI note value can be selected.
Confirm the selection by pressing the Enter button. By doing this, a pad is able to control
parameters like the reverb intensity of a synthesizer depending on how hard the pad is
pressed.
Pad Colour Setting
The colour of the LED backlight of each pad can be changed for a custom set-up. The
smooth RGB colour mixing of the backlight LEDs can be used to create almost any colour
imaginable.
Press the Edit button so that the LED of the Edit button is lit. Then press one of the pads.
Use rotary knobs 1(R), 2(G), 3(B), to adjust the colour. While adjusting the colour, the RGB
values will be displayed. R1 = red, R2 = blue, and R3 = green. By adjusting the intensity of
each, you can create your own custom backlight colour.
Once satisfied with the colour, press the Enter button to confirm. The Edit button backlight
will then switch off.
Use the guide included below and the corresponding RGB values to quickly create common
colours.
Colour
R G B Values
WIT
127 127 127
The information included in this user manual is subject to change at any time and without notification:
Version:
1.0
Date and author initials: 02-11-2020 RV
Revision date and author initials: -
