DeVilbiss Air Power Company 2225CWH, Руководство пользователя

Страница: 20 / 20

DeVilbiss Air Power Company • 213 Industrial Drive • Jackson, TN 38301-9615
QUICK FACTS
CALL 1-800-888-2468 EXT. 2,1
TO FIND A LOCAL AUTHORIZED SERVICE CENTER NEAR YOU
FOR REPAIRS AND SERVICE PART PURCHASES.
GAS
Use fresh high quality gas.
Add stabilizer to fuel tank and run engine for 5 minutes before storage.
OIL
Pump oil: Refer to owners manual supplied with this unit.
Engine oil: Refer to engine manual supplied with this unit.
Some units are equipped with a low oil sensor and adequate oil must be added or
the unit will not start.
WATER
Use only cold water.
Don’t operate unit with clogged or missing water filter/screen.
Don’t operate unit without adequate water supply to pump. Adequate water supply is
a minimum of 20 psi and 5 gpm.
PRESSURE
ADJUSTMENT
The pressure setting is preset at the factory to achieve optimum cleaning. If you
need to lower the pressure setting, refer to the owners manual for proper procedure.
PUMP
Pull gun trigger every 2 minutes while engine is running.
Don’t allow water to freeze in pump.
Siphon RV antifreeze into pump for cold weather storage or long term storage.
BY-PASS
MODE
Never leave unit running for more than 2 minutes without pulling gun trigger; doing so
will destroy pump and void warranty.
THERMAL
RELIEF VALVE
Pump is equipped with a thermal relief valve. If the water overheats, this valve will
open and allow a gush of water to escape. Once the water is released, the valve
closes allowing the pump to operate normally.
HOSE
Don’t allow hoses to contact the HOT engine muffler during or after use.
Never pull the hose to move the unit.
ENGINE
Do not adjust or attempt maintenance without consulting engine manual or an
authorized engine service center.
Add stabilizer to fuel tank and run engine for 5 minutes before storage.
Always turn on the water before starting the engine.
SOAP
CHEMICALS
Use only soaps and chemicals designed for pressure washer use.
NOZZLE
Keep nozzle unclogged. Refer to manual for cleaning procedures.
Chemical/soap cannot be siphoned in high pressure setting. Only in low setting.
MAINTENANCE
SCHEDULE
Follow recommended maintenance schedule for engine & pump. Refer to manuals.
STORAGE
OR
WINTER
STORAGE
Draw clean water through chemical inlet.
Add stabilizer to fuel tank and run engine for 5 minutes before storage.
Don’t allow water to freeze in pump, gun, wand or hoses.
Siphon RV antifreeze into pump for cold weather storage or long term storage.
ALWAYS REFER TO THE MANUALS SUPPLIED WITH THIS UNIT
Pressure Washer Quick Facts