Devatec ElectroVap CMC, Техническое руководство

Страница: 5 / 31

ElectroVap CMC
Water connection
Installation
A cold water service
line
should be used to
supply the unit. The water supply must also satisfy
the following requirements :
• Water quality: 30 to 1000
ppm
• Water Pressure: 1-6 bar
(15 to 90 psi)
• Water Temp: less than 40°C
(100 Deg. F.)
The water supply connection is
on the
bottom of the
unit. All the
C
MC are delivered with a water inlet
hose (500mm long)
(20 in. long) with
3/4“ fitting
s
for direct
connection
to humidifier
&
cold water supply.
A
check
valve should be located on the
cold water service connection to the
unit.
The inlet valve base has a basket filter (
s.a.
page
n°
25
)
. Check periodically for debris.
The Humidifier
C
MC can run with 3 different water
qualities :
TAP WATER
For the maintenance frequency of the cylinder see
the maintenance curve.
SOFTENED WATER
The ElectroVap
C
MC humidifier may be used with
softened water.
IMPORTANT : Softeners must be programmed
correctly
(for Europe :
0° < TH < 2°
)
. Failure to program
the softener correctly may lead to excessive salt
concentration in the steam cylinder. For assistance contact
the softener manufacturer
.
Reverse Osmosis and
Demineralized
Water
The ElectroVap
C
MC humidifier may be used with
Reverse Osmosis or Demineralised water. The
minimum water quality is
30 µs
. On start-up with
new steam cylinder a tea spoon of bicarbonate of
soda must be added.
3
Pho
tos non-contractuelles
The water level must be between (a)
and (b) for the maximum cylinder
capacity.
Flexible hose supply
b
a
AUTOMATIC DRAINING
For sanitation purposes, the steam cylinder is automatically
drained out in case the humidifier is not operated after a
period of 72 hours. This value is factory pre-set.