DEUTZ-FAHR AGROTRON 106 MK3, Руководство по ремонту

Страница: 145 / 150

20-27
MK 3 TTG Parameter Unit Min. Max.
typ
Wert
Description
Page 21: Min/max speed governor
Engine speed position values 1/min 600...2500 5 Engine speed values
AccelPos. Position pts % 0...41 5 Setpoint generator
DrivMap: injection qty
mm
3
/
Hub
0...100
fuel inj. quantity=fct(eng.speed,
Accel. pedal position) (25 values)
Page 22: Vehicle speed governor
Speed limiting km/ora 0 300 40 Veh.speed limiting
Tacho calibration lmp/m 1 150 130 Tachometer constant
VehSpeedLimit: P-factor % 0 100 10 Governor parameter speed limit
VehSpeedLimit: I-factor % 0 100 10 Governor parameter speed limit
VehSpeedLimit: D-factor % 0 100 10 Governor parameter speed limit
EngSpeed:TachometerFail. 1/min 500 4000 2000 Maximum permissible speed after tachometer fail
Tacho Timeout s 0 100 5
Max. consumption l/ora 0 200 200
Page 23: CAN, general settings
CAN bus (on/off) 0 1 0
CAN time out Mon (on/off) 0 1 0
CAN: EMR Adress
Can: Baud Rate kBaud 0 255 0
Can:Start Time Out s 0 100 10
Can: Rx Obj Mincount 0 255 4
Can: Low Voltage V 0 66 9
Can: Volt Timeout s 0 100 30
Can: Rx Obj Missing No 0 255 4
Can: Config Tel On 0 63 0
Can :Dia Tel On 0 2047 1961
Can: Meß Tel On 0 3 1
CAN-Sensor ON/OFF 0 65535
LC1: Eng Speed
Ptl Ref)
1/min 1500 0 4000
LC1: Eng Speed
Pt2 (Upper)
1/min 1500 0 4000
LC1: Eng Speed
Pt3 (Lower)
1/min 1700 0 4000
LC2: Eng Speed
Ptl (Ref)
1/min 0 0 4000
LC2: Eng Speed
Pt2(Upper)
1/min 0 0 4000
LC2: Eng Speed
Pt3(Lower)
1/min 0 0 4000
Page 24: CAN: (7700)Rec/Send Telegr. Objects (controller setting)
Rec: EngineTemperature 0 15 0
Recilmake/
ExhaustCond
0 15 0
Rec: Eng Qii Level/
OilPres
0 15 0
Rec:TSC1 0 15 8
Rec: EMR Engine
Protection
0 15 12
Rec: EMR function shift 0 15 0
SERDIA PARAMETERS