BELT ADJUSTMENTS
:
CENTRE SPINDLE BELT: Fig.2
1:
Place height lever in mid position.
2:
Loosen nut “A” and tighten nut “B” (Fig.2)
TRANSAXLE BELT
:
1:
Loosen the four engine mount bolts.
WARNING! DO NOT OVER TIGHTEN BELTS.
2:
Slide engine forward along slots.
3:
Re-tighten the engine mount bolts.
4:
Adjust centre spindle belt as above.
CUTTER SPINDLE BELTS
: (Fig.3)
1:
Loosen nut “C”.
2:
Push jockey pulley ”D” against belt until tight.
3:
Tighten nut “C”.
REPLACING BELTS:
CENTRE SPINDLE BELT: Fig.2
1:
Uncouple seat switch wire (Bullet connector at rear of seat).
2:
Remove seat panel.
3:
Set cutting deck in mid cutting height position.
4:
Remove belt guide at rear of pulley.
5:
Loosen Nut "B" so that main belt is loose.
6:
Loosen all engine mounting bolts.
7:
Push engine to rear of mower and remove transmission belt.
8:
Remove belt from pulleys and replace.
9:
Fit transmission belt.
10:
Loosen nut "A" till main drive belt is tensioned and tighten nut "B".
11:
Tighten engine bolts and replace belt guide.
TRANSMISSION BELT: Fig.2
1:
Uncouple seat switch wire (bullet connector at rear of seat)
2:
Remove seat panel
3:
Remove fan cover from rear of engine
4:
Loosen nut "B" so that main belt is lose
5:
Loosen all engine mounting bolts and pushing engine back on slots
6:
Remove belt off engine pulley first then transmission pulley.
7:
Fit new belt over transmission pulley then onto engine pulley.
8:
Loosen nut "A" till centre belt is tensioned (it will also tension transmission belt) and tighten nut "B".
9:
Tighten all engine mounting bolts and refit panels.
5
20mm
A
B
Fig.2
Fig.3
C
D
C
D
E
E
C D
