Air-to-water Heat Pump Split Versati
48
SPLIT TYPE
[Notes]
(a) It will not be memorized upon power failure.
(b)
It can be set only when the unit is turned off.
3.2.2.31 Address
It is used to identify the unit in use in the central control system.
[Operation Instructions]
Go to the
FUNCTION
page and locate “
Address
”, then, configure it through the Up/Down key
to set
the address.
[Notes]
(a) It indicates the address of the control and is intended for the group control.
(b) It will not be memorized upon power failure.
(c) The address range is [0,125] and [127,253]
(d) The default address is 1 for the initial use.
3.2.2.32 Gate-Controller(Gate-Ctrl.)
It can be configured to be “
On
” or “
Off
” based on the actual condition.
[Operation Instructions]
Go to the
FUNCTION
page and locate “
Gate-Controller
”, then, configure it through the Up/Down key
, “
On
” or “
Off
”.
[Notes]
(a)
When it is activated, the control will check the card is inserted or not. If inserted, the control will run
normally; if not, the control will turn off the unit and back to the homepage. In this case, any key operation
is ineffective (except for the combined key operation), or a dialogue box will pop up, warning"
Keycard
uninserted!
".
(b) It will not be memorized upon power failure.
3.2.3 Parameter Setting (Parameter Set)
3.2.3.1 User Parameter Setting
At the parameter setting pages, each parameter is configurable, like: water out temperature for cooling, water
out temperature for heating, and water tank temperature etc.
[Operation Instructions]
(1) At the homepage, it is able to go to the
PARAMETER
page by pressing the Function key no.2
.
(2) At the
Parameter Set
page, by the Left/Right key
select the desired option and then by the
Up/Down key
increase or decrease the setting value which will be continuously changed when
pressing and holding the key.
