Installing beacons in the lane
8
© DESIGNA Verkehrsleittechnik GmbH
11
DESIGNA SMART MOVE_Installation_110_ENG.docx
8
Installing beacons in the lane
The beacons installed in the car parks communicate with the SMART
MOVE app on your smart device via Bluetooth Low Energy.
These beacons are pre-configured ready for use at the factory and
installed on site after delivery. To guarantee correct installation, the
beacons have an ID number.
Fig. 4:
Example: Installed beacons at a car park entrance
Two beacons are installed in each lane to facilitate vehicle recognition.
This prevents incorrect parking data from being registered, e.g. when
vehicles enter or exit one behind the other or when several entry or exit
lanes are used.
The beacon on the device
1
provides the app with the recognition data of
the device. The second beacon
2
is used as a reference for unique
identification of the vehicle in the lane.
Bidirectional alignment
When aligning the beacon boxes, make sure they are opposite each
other and facing towards the lane.
ID number
The ID number assigned in the configuration must be observed to ensure
correct installation of the beacons in the lane. It can be found on the label
affixed to the beacon box.
If an ID number was not assigned to the beacon upon
delivery, service technicians can reconfigure the
identification number on site using a tool.
After installation, remove the labels from the beacons.
