www.desatech.com
111826-03H
4
4. Before installing in a solid fuel burning
fireplace, chimney flue and firebox must
be cleaned of soot, creosote, ashes
and loose paint by a qualified chimney
cleaner. Creosote will ignite if highly
heated. Inspect chimney flue for damage.
If damaged, repair flue before operating
appliance.
5. You must operate this log set with fireplace
screen in place and fully closed. Any glass
doors must be open during operation.
6. This log set is designed to be smokeless.
If logs ever appear to smoke, turn off appli
-
ance and call a qualified service person.
Note: During initial operation, slight
smoking could occur due to log curing
and burning of manufacturing residues.
You may wish to add more ventilation by
opening a window.
7. To reduce creation of soot, follow instructions
in
Cleaning and Maintenance
, page 12.
8. Installation and provisions for combus-
tion and ventilation air must conform
with the
National Fuel Gas Codes, ANSI
Z233.1/NFPA 54, Air for combustion and
Ventilation.
SAFETy
Continued
9. Do not run log set
• where flammable liquids or vapors are
used or stored
• under dusty conditions
10. Do not burn solid fuel in fireplace after
installing log set. Do not use this log
set to cook food or burn paper or other
objects.
11. Do not use appliance if any part has been
exposed to or under water. Immediately
call a qualified service technician to in
-
spect room heater and to replace any
part of control system and any gas control
which has been under water.
12. Turn log set off and let cool before servic-
ing, installing or repairing. Only a qualified
service person should install, service or
repair log set.
13. Provide adequate clearances around air
openings.
14. The receiver on this unit (see Figure 12,
page 9) has an antenna that has been
attached with adhesive. DO NOT remove
or alter placement of this antenna as this
will short circuit receiver.
Figure 1 - Log Set in Packing Box
Carton Tray
with Handles
LOCAL CODES
Install and use log set with care. Follow all local
codes. In the absence of local codes, use the
latest edition of the
National Fuel Gas Code
ANSI Z223.1/NFPA 54*
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Battery March Park
Quincy, MA 02269
UNPACKING
CAUTION: Do not remove data
plates from grate assembly. Data
plates contain important warranty
and safety information.
1. Remove contents from side compart-
ments (see Figure 1).
2. Remove log set by lifting tray handles. Set
tray on floor.
3. Remove log set from tray by cutting
zip ties.
4. Check heater for any shipping damage.
If heater is damaged call DESA Heating,
LLC at 1-866-672-6040 for replacement
parts before returning to dealer.
