________________________________________________________________________________________________
__________________________________________________________________________________________________________
Operator Manual for TACT TA-4800 in NSW National Parks & Wildlife Service User Mode G/00123B Issue 1 Page 6
CALLED INDICATOR
If you leave your vehicle and incoming calls are not answered, TACT will register unanswered calls. You can
check this from the radio only.
To Read the Unanswered Call Indicator
1.
Press * 30 # and listen for either "
No calls
" or "
n calls
", where n was the number of unanswered calls.
The unanswered calls register is then automatically reset.
CALL COUNTER
TACT automatically counts the number of calls connected to the field. You can read the call counter from the
radio only.
To Read the Call Counter
1.
Press * 31 #. TACT responds "
Call count nnnn
".
To Reset the Call Counter
1.
Press * 31 0 #. TACT responds "
Call count 0000
".
SYSTEM PERSONAL IDENTIFICATION NUMBER (SYSTEM PIN)
TACT can be programmed to operate only after a valid PIN has been entered. All users on the system are
required to insert the PIN before dialing or programming. It can prevent unauthorised use, and allow multiple
TACT units to be used on the same radio frequency.
To Program the System PIN
1.
Press * # p…#, where p… is the required PIN (1 – 8 digits).
This number cannot be recalled, it can only be over-written.
HOLD
Placing a Call on Hold
1.
Press *1.
To Take the Call off Hold
1.
Press *1 (please wait a few seconds for the call to be returned).