Desighn2000 TACT TA-4800, Руководство оператора

Страница: 14 / 30

________________________________________________________________________________________________
__________________________________________________________________________________________________________
Operator Manual for TACT TA-4800 in NSW National Parks & Wildlife Service User Mode G/00123B Issue 1 Page 11
SYSTEM CONFIGURATION
Programming can be done from the TACT inbuilt keypad, remote telephone or radio.
The programming is the same from the keypad, remote phone or the serial port.
An extra two steps are
required when accessing programming from a phone or radio. After connection, type *67PIN#
(where the default PIN = 1234) to enter programming mode. To exit remote programming mode press
#*#.
1.
Press *6703# to enter system configuration programming mode.
2. Press *nn, where nn is the required option number from the table below.

TACT then reports the selected option number and its current status.
3. Enter a new value as required.

TACT then reports the option number and its new status.
4. Press *# to save and exit, OR
Press # to scroll to the next option OR
Press *nn, where nn is another required option number from the table below.
5. Enter a new value as required.

TACT then reports the selected option number and its new status.
6. Press *# to save and exit (or press ** to abort all changes)
Command Summary
*6703#
* nn where nn is option number
n… =
entry
# = scroll
* * =
abandon
* # = store & end
OPTION CODES
Code Function Range Default Description
*01 Reversal On Idle Ignore
Incoming telephone Calls 0,1 0 0 = enable CPC detection
1 = disable CPC detection
*02 Reversal On Idle Ignore
Outgoing Calls 0,1 0 0 = enable CPC detection
1 = disable CPC detection
*03 Reversal On Answer Ignore 0,1 0 0 = enable ROA detection
1 = disable ROA detection.
NOT USED.
*04 Decadic Dialing 0,1 0 0 = DTMF
1 = Decadic
NOT USED
*05 Dial tone Ignore 0,1, 2-9 1 0 = dial out as soon as dial tone is detected. If no
dial tone within 4 seconds, hang up.
1 = dial out as soon as dial tone is detected. If no
dial tone within 2 seconds, dial regardless.
n = Ignore dial tone and dial after n seconds,
where n = 2 – 9.
*06 Delay After First Digit for
‘outside’ access 0,1 0 0 = no delay
1 = 2 second delay after first digit when dialing.
*07 Loop Break on silence 0,1 0 0 = no loop break
1 = momentarily hang up phone line when silence
detected for 20 seconds on an incoming call.
NOT IMPLEMENTED
*08 Digit Limit 00-21 21 21 = maximum digit limit
other = max number of digits that can be dialed
by TACT
*09 Hook flash Time 0-3000 0100 ms for hook flash