DESCO WEST
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Website:
TB-3059
Page 3 of 3
© 2020 DESCO INDUSTRIES INC
Employee Owned
Operation
Enter the sensor’s field of view. The blue LED will
illuminate upon activation. The ionizer will remain
powered as long as something is in the sensor’s view.
Movement is not necessary.
Leave the sensor’s field of view to activate the shutoff
delay timer. The Ionizer Motion Sensor’s LED will turn
off and unpower the ionizer once the preset deactivation
delay time is reached.
Figure 6. Replacing the fuse in the Control Unit
Limited Warranty, Warranty Exclusions, Limit
of Liability and RMA Request Instructions
See the Desco Warranty -
Desco.com/Limited-Warranty.aspx
Figure 4. Using the Ionizer Motion Sensor with the
Figure 5. Using the Ionizer Motion Sensor with the
Chargebuster® 3-Fan Overhead Ionizer
Maintenance
The fuse located in the Control Unit may be replaced by
removing the power cord and opening the fuse drawer
at the IEC inlet. The Control Unit uses one 5A, 250V
slow blow fuse. DO NOT use other ratings as it may
pose a safety hazard.
Specifications
Maximum Input
Voltage and Frequency
5A @ 120VAC, 50/60 Hz
Operating Temperature 50 to 95°F (10 to 35°C)
Environmental
Requirements
Indoor use only at altitudes
less than 6500 ft. (2 km)
Maximum relative humidity
of 80% up to 85°F (30°C)
decreasing linearly to 50% @
85°F (30°C)
Dimensions
(Sensor)
3.0" L x 2.0" W x .9" H
(76 mm x 51 mm x 23 mm)
Dimensions
(Control)
2.7" L x 2.0" W x 1.8" H
(69 mm x 51 mm x 46 mm)
Weight
(Sensor)
0.1 lbs. (0.05 kg)
Weight
(Control)
0.3 lbs. (0.1 kg)
Fuse
5A, 250V, slow blow
Country of Origin
United States of America
