Desam DMD2 Series, Руководство пользователя

Страница: 22 / 43

21 / 43
7
、
The serial number of the microphone, generally with the input channel for equipment, is the channel
number of the MAC is connected. Among them with # # said mike number for a virtual number, can only be used
to set the default MAC.
8
、
Priority series is smaller, the higher priority level, when the priority phase at the same time, according to
the trigger priorities; As two MAC address at the same time, the camera automatically turn to the first series of
small (i.e., is a high priority level) of bits or send mike the corresponding preset preferred series small (i.e., is a
high priority level) of the corresponding command mike; But if both mike's priority is the same, subject to first
check the signal.
9
、
Enable this MIC Settings: you can set all parameters of mike all good, but when used according to the
actual situation, only enable one part.
10
、
Preset point, serial number, camera address, protocol and the camera, must be the actual connection
and video cameras.
11
、
custom command refers to the mike check matrix to have when the input signal (usually someone
speaking), automatically send corresponding commands to the serial port defined, second can also be set in
advance orders, but not check the "enable custom orders", the device will not automatically send, but can still
point "send" button, will at any time in the input box commands sent to the specified serial port.
12
、
click "save" to save parameters to the device, when the channel of the MAC address associated
with the corresponding cameras. And then through the "enable the microphone Settings" option to determine when
to enable tracking the microphone Settings are valid.
13
、
camera Settings is a camera debug interface, general debugging good camera position before the
start of the track, the last part of the parameters will be stored in the camera.
14
、
a serial port Settings, first serial port has 2 (232, 485), with that of the back port after the cradle
head camera is connected.
15
、
addresses and protocol type, followed by the camera, video camera, actual address please refer to
the camera, the protocol and the camera model.
16
、
Preset point number is defined the camera, and then adjust the up, down, left, right, and parameters
such as focal length, aperture, will define the camera Settings;
17
、
Click "save" to save parameters on the camera, click on the "remove" to delete the current precast
point information, click the "call" point of view the current preset saved by the camera position.
Note: the address of a video camera can contain multiple preset points, but a preset point only address
corresponding to a camera. Camera Settings and mike Settings are preset point, serial number, address of
the camera, protocols, several parameters, the application needs to consider the actual situation.
232 and 485 how to switch
If a video camera connected to the audio processor in the 232 mouth and debugging is ok, location does not
change and disconnect an audio processor with another 485. The parameters of the camera keep don't need to reset,
you just need to adjust the microphone Settings, but at the moment, port should choose 485.