![background image](http://html1.mh-extra.com/html/desa/pd35vpa/pd35vpa_owners-manual_2486469007.webp)
www.desatech.com
113530-01A
7
SYMPTOM
Burner fails to light
Burner lights but goes out when
automatic control valve button
is released
Maximum burn rate is low
TROUBLESHOOTING
WARNING: Never attempt to service heater while it is connected
to propane/LP supply, operating, or hot. Severe burns can occur.
POSSIBLE CAUSE
1. Propane/LP supply valve closed
on propane/LP cylinder
2. Blockage in burner/orifice
elbow/hose and regulator as-
sembly
3. Piezo ignition system not
sparking
1. Not enough warm-up time
2. Low gas pressure
3. Thermocouple loose or needs
to be replaced
4. Automatic control valve needs
to be replaced
5. Thermocouple gap is too
great.
1. Low gas pressure
2. Low fuel supply
3. Restriction in burner/orifice
elbow/hose and regulator as-
sembly
REMEDY
1. Open propane/LP supply
valve slowly
2. Clean burner/replace orifice
elbow/hose and regulator as-
sembly
3. Verify ignitor electrode gap is
.20". Check wire lead for dam-
age. Replace piezo ignitor and/or
ignitor electrode as necessary
1. Relight, hold automatic control
valve button in 30 seconds
2. Check propane/LP cylinder
for proper gas supply
3. Tighten connection or replace
thermocouple
4. Replace automatic control
valve assembly
5. Tip of thermocouple should
just touch the emitter material.
Loosen bracket screws to move
thermocouple closer to burner.
Be careful not to allow ignitor
to touch. Maintain 0.20"
1. Check gas supply; check
regulator output
2. Consult propane/LP gas supplier
3. Clean burner/replace orifice
elbow/hose and regulator as-
sembly
SPECIFICATIONS
Rating
High
35,000 Btu/Hr (39.927 Kj/Hr)
Low
22,000 Btu/Hr (23.211 Kj/Hr)
Fuel
Propane Vapor Only
Fuel Consumption
Gallons (Liters)/Hour
Min .24 (.91), Max .38 (1.44)
Pounds (kg)/Hour
Min 1.02 (.46), Max 1.62 (.73)
Supply Pressure (To Regulator)
Maximum
200 psi (1,379 Kpa)
Minimum, for input adjustment
20 psi (137,9 Kpa)
Manifold Pressure psi (Kpa)
High
1.8 psi (12,41 kPa)
Low
1.9 psi (13,10 kPa)
Ignitor Gap
0.120"
Minimum Temperature
-20°F (29°C) Surrounding Air Temperature
Size - L x W x H
Heater
17.5 x 15 x 42 inches (.44 x .38 x 1.06 m)
Carton
22 x 17.5 x 45 inches (.56 x .44 x 1.14 m)
Weight
Heater
3.2 kg (7 lb)
Carton
4.1 kg (9 lb)