www.desatech.com
117889-01B
5
Most halogen light bulbs are rated to last approxi-
mately 1800 hours. Like all light bulbs, halogen
bulbs require periodic replacement. When the
bulbs in your unit have burned out you will notice
or more of the following:
• Flame is dim or dark in certain areas
• Log set ember bed appears dim or dark in
certain areas
WARNING: Do not install
replacement bulbs that exceed
specified maximum watts.
CLEANING AND
MAINTENANCE
Continued
Figure 4 - Replacement Light Bulb
Your unit must be opened in order to replace the
light bulbs. To reduce the number of times you
need to open the unit, replace all bulbs at the
same time if they are close to the end of their
rated life.
Tools Required: Phillips Screw Driver
Replacing Flame Generation Bulb
1. Unplug unit from the power supply.
2. Remove the six screws from the back of stove
as shown in Figure 5. Remove back plate.
3. Locate the flame generation cylindrical
drum (see Figure 6). It is constructed of two
removable halves. They are two matte black
sheet-metal pieces with holes in them, either
of which can be removed from the unit.
4. Squeeze half of drum cylinder until its top
edge clears the top drum track. Remove the
bottom edge of the cylinder drum from the
bottom drum track. This will give you access
to the light bulbs.
Note
: Do not exert exces-
sive pressure on the drum cylinder as this may
cause damage.
5. Remove spring clip. Hold socket and pull out
old bulb.
6. Hold socket and push in new bulb. Replace
spring clip.
7. Insert bottom edge of removed cylinder half
into bottom of drum track. Gently squeeze
drum cylinder until it's top edge fits into top
drum rack.
Figure 5 - Screw Locations
Screws
Screws
Figure 5 - Cylinder and Bulb Locations
Cylinder
Flame
Generation
Bulb
Ember Bed
Bulb
8. Secure the rear cover of the unit to the main
frame by reattaching the 6 screws remove in
step 1.
Replacing Ember Bed Bulbs
1. Unplug unit from the power supply.
2. Remove the six screws from the back of stove
as shown in Figure 5. Remove back plate.
3. Locate the ember bed light bulb in the bottom
of the unit shown in Figure 6. It is under the
flame generation cylindrical drum toward the
front of the unit.
4. Remove spring clip. Hold socket and pull out
old bulb.
5. Hold socket and push in new bulb. Replace
spring clip.
6. Secure the rear cover of the unit to the main
frame by reattaching the 6 screws remove in
step 1.
