www.desatech.com
111347-01F
5
Figure 1 - Product Identification
Meadowbrook Oak Logs with Thermostat
Control
Echo Valley Oak Logs with Manual
Control
Control
Knob
Control
Cover Log
Control
Cover Log
Piezo Ignitor
(behind log)
Piezo Ignitor
(behind log)
Control
Knob
PRODUCT
IDENTIFICATION
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system re
-
quires no matches, batteries or other sources to
light heater.
AIR FOR COMbUSTION
AND VENTILATION
WARNING: This heater shall not
be installed in a confined space
or unusually tight construction
unless provisions are provided
for adequate combustion and
ventilation air. Read the following
instructions to insure proper fresh
air for this and other fuel-burning
appliances in your home.
Today’s homes are built more energy efficient
than ever. New materials, increased insulation and
new construction methods help reduce heat loss
in homes. Home owners weather strip and caulk
around windows and doors to keep the cold air out
and the warm air in. During heating months, home
owners want their homes as airtight as possible.
While it is good to make your home energy effi
-
cient, your home needs to breathe. Fresh air must
enter your home. All fuel-burning appliances need
fresh air for proper combustion and ventilation.
Exhaust fans, fireplaces, clothes dryers and fuel
burning appliances draw air from the house to
operate. You must provide adequate fresh air for
these appliances. This will insure proper venting
of vented fuel-burning appliances.
PROVIDING ADEQUATE
VENTILATION
The following are excerpts from National Fuel
Gas Code, ANSI Z223.1/NFPA 54, Section 5.3,
Air for Combustion and Ventilation.
All spaces in homes fall into one of the three fol-
lowing ventilation classifications:
1. Unusually Tight Construction
2. Unconfined Space
3. Confined Space
The information on pages 5 through 7 will help
you classify your space and provide adequate
ventilation.
PRODUCT FEATURES
OPERATION
This heater is clean burning. It requires no outside
venting. There is no heat loss out a vent or up a
chimney. Heat is generated by realistic flames. This
heater is designed for vent-free operation with flue
damper closed. It has been tested and approved
to ANSI Z21.11.2 standard for unvented heaters.
State and local codes in some areas prohibit the
use of vent-free heaters. This heater may also be
operated as a vented decorative (ANSI Z21.60)
product by opening the flue damper.
SAFETY DEVICE
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for vent-free room
heaters. The ODS/pilot shuts off the heater if there
is not enough fresh air.
