Derksen PHOS 25, Руководство пользователя

Страница: 5 / 24

Safety Instruc�ons
PHOS move 5
• Never pour or spray any liquids on the projector. The
projector is only suitable for indoor use in dry areas
and must never be exposed to rain or humidity.
1.4. Heat and fire hazard
• Do not operate the device near highly flammable sub-
stances (e.g. alcohol or gasoline).
• The projector may only be operated when securely in-
stalled and placed on a fixed angle. A projector which
has toppled over or a projector head which has drop-
ped down can cause surfaces to catch fire.
• The projector’s beam of light can reach high tempera-
tures at close range. Keep flammable materials at a
safe distance (0.5 m) from the light exit point. This di-
stance increases the more projectors are used to illu-
minate a loca�on. Make sure to keep flammable
materials (e.g. curtains) far away from a hazardous
area.
• The projector heats up during opera�on. Risk of bur-
ning! Let the projector cool for at least ten minutes be-
fore changing a projec�on mo�f or doing anything
else on the projector.
• The projector is ac�vely or passively cooled depending
on its type and requires an unrestricted flow of air for
cooling. Keep a minimum distance of 30 cm to walls
and objects on all sides.
• Do not cover the projector with sheets or insula�ng
materials or operate it in enclosed cases. Cooling is
only effec�ve if the hot air being released can escape
and cool air can freely flow.
• Protect the front lens from direct sunlight. Sunlight is
concentrated through the front lens and can cause da-
mage and fire inside the projector.
1.5. Op�cal radia�on hazard
The projector is classified in risk group 2 (RG-2) of the pho-
tobiological hazard classes in accordance with the DIN EN
62471-5:2015 standard. The following safety regula�ons
must be observed to combat the risk of glare caused by vi-
sible op�cal radia�on:
• Do not stare directly into the beam of light.
• Never look directly into the beam of light at close ran-
ge (<1 m). Permanent eye injury may occur if you ex-
pose yourself to the beam of light within the
hazardous area.
• Install the projector in a loca�on where a distance of
more than 1 m can be kept from the eyes of people
exposed to the beam of light.
• Only change the projec�on mo�f when the projector
is switched off.
• Do not make any modifica�ons to the projector’s op�-
cal components (projec�on lens, lenses, illuminants).
Only use original accessories, and only replace dama-
ged components with original spare parts. A device
which has been modified may be categorised into a
higher photobiological risk group.
1.6. Assambly instruc�ons
The projector must be firmly a�ached to a stable and load-
bearing surface or structure.
Local regula�ons on the safety of buildings, especially regu-
la�ons on places of assembly, must be observed:
• Building regula�ons
→ Safety of construc�on sites and buildings
• Regula�ons on places of assembly
• Regula�on on the construc�on and opera�on of speci-
al buildings (Special Construc�on Regula�on)