Installa�on
PHOS rotator
27 / 56
En
gl
is
h
4.4. Connec�ng op�on for ligh�ng con-
trol (DALI / 1–10V / DMX)
In addi�on to the basic version, the PHOS rotator is also
available as either a DALI, a 1–10V, or a DMX-version. Com-
pared to the basic version, these offer the possibility, to
switch the projector on and off and to change its bright-
ness via a ligh�ng control system.
Depending on the version, either a 1-10V line or a DALI line
can be connected to the two-pole connec�on terminal in
the device stand.
1.
Release the cable glands on the back of the device and
remove the blind plugs.
2.
Feed your control cable in and connect it to the re-
spec�ve terminal.
3.
Tighten the screw connec�on and cable glands.
4.5. Se�ng the DMX address
The control panel for DMX addressing is embedded in the
cover plate behind the housing cover.
•
Use the three selector switches to set the address you
want.
•
When assigning addresses, please take into account
that three channels are reserved by the device.
The DMX version has two three-pole terminals installed at
this point, to which the input and output cables are con-
nected.
ATTENTION! Poten�al Damage.
A ven�la�on element has been installed next to the
cable glands. This element must NOT be dismantled, ro-
tated or modified in any way. This is the only way to en-
sure its waterproof capability.
