INDUSTRIAL VACUUMS
Mini BULL - TB
USE AND MAINTENANCE MANUAL
Mini Bull - TB Manual
page 31 of 41 pages
5.2
General safety regulations
Attention!
All the operations described above must be carried out with the plug disconnected from
the socket (and the air disconnected from the CCA system).
Before starting any maintenance or cleaning operation, wear suitable PPE (protective
clothing, goggles and/or gloves, etc.) according to the work to be done.
Place a sign on the vacuum with the message:
“MACHINE UNDER MAINTENANCE
DO NOT START
”
Before resuming operation, verify the entire system according to start-up procedures.
Run a few trial operating cycles after every maintenance operation to ensure proper
machine operation.
Failure to comply with these precautions can cause series injuries to the personnel.
Maintenance operations must be carried out by trained technicians specialised in the following sectors:
• Mechanical maintenance
• Electrical maintenance
It is the Safety Manager's duty to ensure the professionalism and skills of these technicians.
Before starting any maintenance operation, the Safety Manager must
:
- Keep unauthorised personnel out of the work area.
F
Ensure that the necessary tools are in good conditions and readily available to
the maintenance technician.
F
Ensure that the maintenance technician is equipped with the personal
protective equipment required for the specific operation (gloves, goggles,
shoes, mask, etc.).
F
Ensure that the maintenance technician has carefully read the instructions
contained in this manual and knows the operation of the vacuum and its
components perfectly well.
- Ensure that there is enough light and, if necessary, provide 24 Volt torches.
Before starting any maintenance operation, the Maintenance technician must
:
- disconnect all power supplies and safely lock the vacuum and
- disconnect the compressed air supply (where available).
