Denver HSA-120, Инструкция по установке и эксплуатации, Страница: 7 / 28

12 13
Specifications
Power supply
DC 12V (A23 12V Battery x 1)
Static current
≤ 30 uA
Alarm current
≤ 15 mA
Transmission distance
≤80 m (in open area)
Radio-frequency
433 MHz (±75 KHz)
Housing material
ABS plastic
Operating conditions
Temparature: -10°C~55°C
Relative humidity: ≤ 80% (non-condensing)
Transmitter dimensions (LxWxH)
60 x 45 x 18 mm
Magnet dimensions (LxWxH)
45 x 19 x 17,5 mm
3.2.4 RFID Tag
Features
The RFID tag enables you to disarm your system.
Register the RFID tag in the alarm system
Enter Connection Mode on the control panel.
Swipe the RFID tag in front of the RFID reader on the control panel.
Specifications
Dimensions
30 x 30 x 6 mm
3.2.5 Register an Additional Denver External Siren
The control panel of the HSA-120 features a built-in 90 dB siren.
Your Denver security systems supports additional indoor and/or outdoor sirens (NOT included) so to
enable you to extend your system according to your needs.
Design
Magnet
Transmitter
LED indicator
PCB Layout
LED working indicator
Zone setting
A23 12V Battery
Tamper switch
LED indications
Blinks once : the door or window is open and the transmitter sends a signal to the control panel.
Blinks quickly: Low power indication: the batteries must be replaced.
（
You will be informed by SMS
when the batteries are low if the door/window contact is registered in the control panel. ）
Register in the control panel
Enter Connection Mode on the control panel
Then separate the magnet from the transmitter.
To check if the registration is complete, arm the system and separate the magnet from the transmitter
again by opening the door or window on which it is installed. If the siren rings out, the registration
is successful.
Installation
- Open the case and remove the battery activation strip.
- Mount the sensor on the door and the magnet on the
door frame.
- Make sure the magnet is placed above the transmitter.
- Mount the magnet max. 1 cm away from the transmitter
and secure the transmitter and magnet with double-
sided tape or screws.
- Avoid mounting the sensor in areas with a large amount
of metal or electrical wiring such as a furnace or utility
room.