Denver HSA-120, Инструкция по установке и эксплуатации, Страница: 4 / 28

6 7
3.1 Connect the Control Panel
The SIM CARD (not included) must have 2G support. Please note that some SIM cards are only 3G SIM
cards (no 2G) and so cannot be used for this alarm system. Also the SIM card shall be without simlock. If
the card is simlocked you need to remove this (e.g. in a mobile phone) first.
1. Insert the Sim card (NOT included) in the control panel as described in the drawing below.
2. Plug the adaptor into AC power socket.
3. Switch the device on.
4. Turn on the control panel.
3.2 Enter Connection Mode
1. Press the “#“ key. Then press the “1“ key on the control panel to activate the connection mode. The
Connection LED indicator lights up. Trigger the wireless accessory to connect it to the control panel.
2. Press the Disarm key ( ) on the control panel to exit the Connection mode.
3. While in Setup mode, enter “* 22 * password *” (
DEFAULT PASSWORD:1234
) on the control panel to
clear all the connected accessories.
3.2.1 Wireless Remote Control
Home Mode Arm
SOS
Disarm
LED indicator
Arm the system
Press the Arm button " " to arm the alarm
system. The LED indicator lights up (the
control panel beeps once). The system is
armed.
If an intruder is detected, the siren rings
out. (The siren turns off after 3 minutes as
per default settings.) In the meantime, the
system dials the pre-stored phone numbers
automatically.
Disarm the system
Press the Disarm button " " to disarm the
alarm system. The LED indicator turns off
(the control panel beeps twice). The system
is disarmed.
Home Mode
Press the Home Mode button " " on the
remote control. The system state LED is on
and flashes. All the sensors in regular zones
are armed except those in the Home Mode
zone. The sensors in the Home Mode zone are
disarmed so that users can move inside their
home.
SIM