Denver HSA-120, Инструкция по установке и эксплуатации, Страница: 2 / 28

2 3
1. INTRODUCTION
1.1 Box Contents
1.2 Features
1.3 Recommendations
1.4 Warnings
2. CONTROL PANEL DESCRIPTION
2.1 Control Panel Features
2.2 Specifications
3. START WITH THE CONTROL PANEL
3.1 Connect The Control Panel
3.2 Enter Connection Mode
3.2.1 Wireless Remote Control
3.2.2 Wireless Motion Detector
3.2.3 Wireless Door/ Window Contact
3.2.4 RFID Tag
3.2.5 Register An Additional Denver External
Siren
3.2.6 Zone Setup Of Accessories
3.2.7 Clear Accessories
4. ENTER SETUP MODE
4.1 Ringing Time Of The Siren
4.2 Exit Delay & Entry Delay
4.3 Change Password
4.4 Restore Default Settings
4.5 Store Phone Numbers
4.6 Delete Phone Numbers
4.7 Exit Setup Mode
4.8 Alarm Response When Being Out Of
Home
4.9 Control By Phone Call
4.10 Sire Volume
5. TELEPHONE CALL/ EMERGENCY CALL
6. CONNECT MORE OPTIONAL ACCESSORIES
(NON-EXHAUSTIVE LIST)
1.INTRODUCTION
Thank you for purchasing the DENVER - HSA-120 wireless security system.
Read carefully this manual to get the best experience with this product. Keep this manual for future
reference.
1.1 Box Content
- 1 x Control Panel (with internal siren)
- 2 x Remote Controls
- 2 x Wireless Motion Detector
- 2 x Wireless Window / Door Contact
- 2 x RFID Tags
- 1 x AC Adaptor
- 2 x 800 mAh Battery
(8h in standby mode)
1.2 Features
- Wireless alarm system
- Easy to install
- Control from distance by phone call
- Supports up to 10 Remote Controls, 50 Wireless Accessories
and 50 RFID Tags
- Radio-frequency security of the accessories: more than one
million code combinations
- Easy registration of new accessories
- Built-in 90dB siren to deter potential intruders
- Can store up to 5 phone numbers and 5 SMS numbers
- Arm, disarm and monitor from distance by phone operation
1.3 Recommendations
For your safety, it is recommended to follow the following precautions:
- Do not forget to arm the control panel during your absence and make sure it works properly.
- Do not forget to lock the doors, windows and other ways out of your home.
- Always keep your remote control with you and do not leave it visible or noticeable.
- To optimize the operation of the alarm system, it is recommended to select carefully the location where
each accessory will be installed. It is recommended to mount the detectors on a smooth wall, to ensure
the proper use of the tamper switch.
- Accessories purchased separately must be connected to the control panel manually.
- Wait until the end of the auto-test before putting back the cover of the detector.
- If you do not use this product for a long time, remove the batteries to optimize their lifespan.
- Do not cross the beams of different motion detectors.
1.4 Warnings
- The control panel is provided with a separate battery. Do not scrap used batteries anywhere. They shall
be recycled in accordance with the EU Directives 91/157/EEC and 93/86/EEC.
- Do not open the case of the control panel and do not repair it yourself. If you encounter an issue with the
product, contact a qualified personnel (technician or manufacturer’s service).
- Take care of this product and do not let water get into it as it may damage the product.
- Place the control panel in a cool, dry and well-ventilated area. Do not install detectors near heating,
cooling, or ventilation.
- Do not use detergent or other flammable materials to clean this unit.
- Do not let your device fall on the floor.
- Remove the battery holder cover with care.
- DENVER Electronics is not to be held responsible in case of burglary, theft, loss or damage to house /
persons/ other, power cut off or any other issues.
7. CONTROL PANEL OPERATIONS
8. SMS OPERATIONS
8.1 Store Phone Numbers For SMS Notifications
8.2 Disarm The System
8.3 Settings Enquiry
8.4 Store Phone Numbers
8.5 Rename Zones
8.6 SMS Alert For Accessory Low Battery
8.7 Rename RFID Tag
8.8 Entry and Exit Delay Time
8.9 Siren Volume and Ringing Time
8.10 Change The Password
8.11 Change System Language
8.12 Restore System to Factory Settings By SMS
9. FAQ
10. STANDARDS
Features
ENG